SUPPORT: INSTALLATION
Inside the VMOD Box
• VMOD Bluetooth remote control (battery installed)
• Audio attachment cable (1/8 male stereo to dual RCA female)
• Power cable (white locking Molex connector with four wires, one white, one yellow and two black)

Automotive Installation Instructions
Install VMOD in an accessible area, inside the vehicle and away from moisture and heat. For marine applications, install VMOD in an area that remains dry. Never mount VMOD in engine compartments, vehicle exteriors or in exposed truck beds. Not recommended for motorcycle or personal watercraft use. Always ensure VMOD remains dry and free from moisture. (NOTE: NEVER use any other power source cable except for original VMOD power cables. Use of any other cable will result in catastrophic failure or possible fire. If needed, Replacement VMOD power cables can be obtained through the CONTACT page, or by calling VMOD customer service at 1-951-272-1996. Drivers should never operate VMOD while vehicle is in motion.

Wiring VMOD
12v white to accessory
• The white wire must connect to “accessory” on the ignition switch. This is when you turn your vehicle on but the engine does not start.

12v yellow to constant (power)
• The yellow wire is a constant power feed to the VMOD and must have an inline fuse no larger than 5amps and must be located as close as possible to the power source.

Black ground (x2)
• The two black wires are grounds and can be combined and extended to a proper grounding location. TV Out on VMOD to AUX in on video system (supplied RCA)

Tools / Materials Needed For Installation
• Phillips head screwdriver or cordless drill
• Wire strippers / crimpers
• 12-16 gauge wire (black, white and yellow)
• Inline fuse no larger than 5amps
• Barrel end wire connectors
• Ring terminal wire connectors
• Electrical tape
• Multimeter (Optional)